ECW Standard Bearer 6

When I tried to add sculpted nails to the flag staff, the moisture from the water needed to smoothen the putty destroyed the paper flag. The piece was set aside until I had figured a way to overcome this problem.

Finally I have  decided to make the flag out of thin copper sheet. A piece of the same size flag was cut out and rolled out flat to remove any kinks. The edge to encircle the staff was gently rounded and rolled around the staff tightly. The staff was pulled out and re-epoxied into position. Excess epoxy was wiped off.

Nails were sculpted along the flag staff.

The figure itself was further refined.